How to Set the Cycling Computer

Modern cycling computer is an electronic device that allows you to receive traffic information options when cycling. Set your computer to the bike usually takes some time.

Typically, complete with a bicycle computer is always a special mounting platform just like bicycle phone mount, reed and the magnet on the spokes, lining and tie. Theoretically bicycle computer can be installed at any place on the spokes of a wheel. Still, we recommend positioning the magnet close to the hub to reduce the speed and increase the time that is needed to operate the reed switch. If you decide to fix the computer next to the rim with a large wheel size, display may not be accurate. 

So, to begin with bike computer, attach the sensor to the mounting bolt or the plug. Be sure to adjust the position of the magnet and the reed switch. Almost all of the wired computers come with a special protective jacket of plastic, which provides a secure hold wires to the frame. This wire can wrap a special transparent tape made ​​of polyester. By the way before winding wire, check the purity of the fork and the frame. After installation of the magnet and the reed switch is necessary to remove the front wheel for easy lay of cables.

The wires from the bike computers, set back must take place under the lower rear triangle feathers. There they will be hardly visible. On the mountain bike or hybrid models of the wire can be attached to the cable shift. If that bike without switches gears on the steering wheel, route the cable from the bottom of the pipe to the bottom of the front brake cable. Then it will be possible to let up. It is recommended to leave the segment sagging wire. Also slack between the loop and the tire should leave a small gap. And be sure to take care that the loop does not interfere with gear shifting.

BTW, you can buy bicycle computers at Banggood. Besides, you can easily get other bike accessories (e.g. bike pouch) there with high quality and reasonable prices.